Siderise B Series Fixing Bracket
Supporting brackets for use in the installation of Siderise Cavity Barriers and Firestops. Available in Galvanised or Stainless Steel depending on project requirements. Supplied in a 25mm width in a range of lengths to suit the required void size.
Developed specifically for Siderise
Siderise B Series fixing brackets provide robust support for our cavity barriers and firestops, and are a requirement as part of the tested and certified system. Brackets can be rapidly installed via penetration into the barrier and then fixing back to the supporting construction. Both galvanised (Z275) and Stainless (304) grades are available, depending on project need e.g. environmental conditions. See product data sheets, installation instructions and standard details on the specific product pages for further information.
Siderise B Series brackets are designed for quick and easy installation of specified Siderise products to supported system interfaces. B series brackets are currently supplied for installation with Siderise products such as CW-FS,CW-CB,CVB, RV, CH, EW, TW and RF. Please refer to each individual product technical datasheet and installation instructions to ascertain the correct bracket specification for the application and void dimensions on your project.
Table1: Bracket Dimensions
| Product Ref. | Length(mm) | Width (mm) | Thickness Galv(mm) | Thickness SS(mm) |
|---|---|---|---|---|
| B65/110 | 220 | 25 | 1.0 | 0.9 |
| B195 | 320 | 25 | 1.0 | 0.9 |
| B355 | 505 | 25 | 1.0 | 0.9 |
Please note: Length of bracket provided is measured in flat form from tip to tip.
Table 2: Pre -Galvanised Mild Steel Properties
| Properties | Value |
|---|---|
| Description | Pre-Galvanised Mild Steel Brackets |
| Grade | DX51-D |
| Tensile Strength Rm(N/mm2) | 270 - 500 |
| Coating Weight | Z275 Zinc (Min Av triple spot coating mass g/m2) |
| General Characteristics | Hot Dip Galvanised giving sacrificial protection to all areas after forming and fabrication |
| Dimensional Tolerances | Length +/- 1.0mm, Width and Thickness +/-0.08mm |
Table 3: Stainless Steel Grade 304 Bracket Properties
| Properties | Value |
|---|---|
| Description | Stainless Steel Brackets |
| Grade | 304 |
| Tensile Strength Rm(N/mm2) | 550-700 |
| General Characteristics | Widely used stainless chromium-nickel steels. General purpose grades with good resistance to atmospheric corrosion and many organic and inorganic chemicals |
| Dimensional Tolerances | Length +/- 1.0mm, Width and Thickness +/-0.08mm |
Note: Stainless steel 316 grade available subject to minimum order quantity. Please contact our customer service team: customer.service@siderise.com for
For technical advice or support please contact: technical.services@siderise.com
For Installation Training or Site Inspections please contact: site.services@siderise.com
The information in this datasheet is believed to be accurate at the date of publication. Siderise has a policy of continuous product improvement and reserves the right to alter or amend the specifications of products without prior notice. Siderise does not accept responsibility for the consequences of using the products described outside of the recommendations within this datasheet. Expert advice should be sought where there is any doubt about the correct specification or installation of Siderise products.
Augmented Reality
Point your camera at the QR code. Tap the banner that appears on your screen.