Siderise B Series Fixing Bracket(Pre-drilled)
Siderise B Series brackets are designed to support the installation of specified Siderise products at defined system interfaces. B Series brackets are available for use with a range of Siderise products, including CW-FS, CW-CB, CVB, RV, CH, EW, TW, RF, PC-FS, PC-CB and IC-FS systems. The required bracket specification will vary depending on the product, application, substrate and void dimension. Refer to the relevant product Technical Data Sheet and installation instructions for project-specific specification and installation requirements.
Table1: Bracket Dimensions
| Product Ref. | Length(mm) | Width (mm) | Thickness Galv(mm) | Thickness SS(mm) |
|---|---|---|---|---|
| B65/110 | 220 | 25 | 1.0 | 0.9 |
| B195 | 320 | 25 | 1.0 | 0.9 |
| B355 | 505 | 25 | 1.0 | 0.9 |
Please note: Length of bracket provided is measured in flat form from tip to tip.
Table 2: Pre -Galvanised Mild Steel Properties
| Properties | Value |
|---|---|
| Description | Pre-Galvanised Mild Steel Brackets |
| Grade | DX51-D |
| Coating Weight | Z275 Zinc (Min Av triple spot coating mass g/m2) |
| General Characteristics | Hot Dip Galvanised giving sacrificial protection to all areas after forming and fabrication |
| Dimensional Tolerances | General: ±1.00mm |±2.0º |
Table 3: Stainless Steel Grade 304 Bracket Properties
| Properties | Value |
|---|---|
| Description | Stainless Steel Brackets |
| Grade | 304 |
| General Characteristics | Widely used stainless chromium-nickel steels. General purpose grades with good resistance to atmospheric corrosion and many organic and inorganic chemicals |
| Dimensional Tolerances | General: ±1.00mm |±2.0º |
For technical advice or support please contact: [email protected]
For Installation Training or Site Inspections please contact: [email protected]
For technical advice or support in the Middle East, India or Asia Pacific contact: [email protected]
The information in this datasheet is believed to be accurate at the date of publication. Siderise has a policy of continuous product improvement and reserves the right to alter or amend the specifications of products without prior notice. Siderise does not accept responsibility for the consequences of using the products described outside of the recommendations within this datasheet. Expert advice should be sought where there is any doubt about the correct specification or installation of Siderise products.
